HPR4526: Baofeng and SDR++

This show has been flagged as Clean by the host.

Goal: send a voice signal on VHF or UHF, receive and record with SDR via RTL dongle

Core Problem and Resolution

An issue may have been a hardware I/Q Imbalance  in the RTL-SDR, which suppressed the desired signal, resulting in very low output volume that required excessive manual amplification.

• Initial Problem:  Very quiet, barely audible recorded audio, initially on UHF 433 MHz
• Key Discovery:  An  I/Q imbalance  caused a repeating signal "image" in the spectrum,
• Frequency Change:  Switched to the  VHF 145.500 Mhz  band,
• Gain Override: To overcome the defect and the failing AGC, gain stages were manually adjusted:
• Squelch:   Squelch (SQL) was set to OFF (0)  to prevent the software from muting the quiet, legitimate signal.
• Adjusted the final Sound Output/Recording Gain  on the host OS to match the maximized digital output, achieving audible voice.

Summary of Key Radio and Software Settings

Transmitting Radio (Baofeng UV-5R):

• Operation: Simplex (direct radio-to-SDR).
• Mode: Narrowband FM (NFM).

Receiving Software (SDR++):

• AGC:  Disabled (Crucial override).
• RF/Tuner Gain:  Adjust (Inject best signal power).
• AF Gain:  Adjust (Produce loudest digital audio).
• Squelch (SQL):  OFF (0) (Prevent muting of quiet signal).
• Filter Bandwidth:  12.5 kHz(Correct setting for NFM).

The ultimate resolution was forcing input and output gain in SDR++ and volume adjustment in Audacity

Provide feedback on this episode.